Table of Contents
Advertisement
OPERATING INSTRUCTIONS
Maintaining your dryer
Cleaning the exterior
• Clean with a soft, damp cloth. Do not use abrasive substances.
• Protect the surface from sharp objects.
• Do not place any heavy or sharp objects or a detergent box on the dryer.
Keep them in a separate storage area. These items may scratch or damage
the top cover of the dryer.
• Because the entire dryer has a high-gloss finish, the surface can be scratched
or damaged. Avoid scratching or damaging the surface when using the dryer.
Cleaning the drum
• Clean with a damp cloth dampened with a mild, non-abrasive cleaner
suitable for stainless steel and anodized surfaces.
• Remove the cleaner residue and dry with a clean cloth.
Cleaning the control panel
• Clean with a soft, damp cloth. Do not use abrasive substances.
• Do not spray cleaners directly on the panel. The control panel finish may be
damaged by some laundry pre-treatment soil and stain remover products.
Apply such products away from your dryer and wipe up any spills or
over-spray immediately.
Cleaning and inspecting the exhaust system
Inspect and clean the exhaust yearly to maintain optimum performance.
Disconnect the exhaust duct from the dryer and from the exhaust hood (at the
1
exhaust outlet) outside of the building.
Check the interior of the duct and remove any lint accumulation.
2
Make sure that lint is removed from the exhaust hood. Lint may collect in the
3
exhaust hood so that the flappers or louvers will not open or close completely.
After cleaning the exhaust hood, make sure that the flapper or louvers move
4
freely.
Reassemble the exhaust duct and hood, making sure that the joints are secure
5
and sealed.
Operate your dryer and make sure that the exhaust air is not obstructed in the
6
vent and that there are no leaks in the system.
Note: Check and clean the outside exhaust hood frequently to ensure a proper
air flow.
WARNING
Certain internal parts are intentionally not grounded and
may present a risk of electric shock only during servicing.
Service Personal: Do not contact the following parts while
the appliance is energized: Control Board and
Temperature-Regulating Thermistor (located on the Blower
Housing).
www.insigniaproducts.com
12-Cycle Electric and Gas Dryers
41
Hide quick links:
Advertisement
Table of Contents
