U-Line H-3630 Assembly Instructions

H-3630, H-3631
π
H-3632, H-3633
STEEL ASSEMBLY TABLE
TOOLS NEEDED
HARDWARE INCLUDED
• (4) 3/8" x 3" Bolts
• (4) 3/8" Flange nuts
STARTER TABLE
NOTE: Install all bolts and nuts prior to tightening.
Figure 1
1. Unfold leg assemblies. (See Figure 1)
2. Unfold flat braces and line up with holes in leg
assemblies. Install to leg using 3/8" x 3" bolts and
nuts. (See Figure 2)
Figure 2
Flat Brace
PAGE 1 OF 2
1-800-295-5510
uline.com
9/16" Wrench (2)
ASSEMBLY INSTRUCTIONS
3/8 x 3" Bolts
and Nuts
ADjUSTING TABLE HEIGHT
1. Remove pre-installed leg bolt and adjust leg to
desired table height. Reinstall leg bolt and nut.
(See Figure 3)
NOTE: When adjusting to the lowest height
setting, the flat brace bolts must be removed
from the leg assemblies. Reinstall flat brace
bolts after leg bolts are inserted.
Figure 3
Desired
Table
Height
2. With the aid of a helper, turn table upright.
(See Figure 4)
Figure 4
3. If the table is a stand alone table, all nuts can be
tightened to 40-50 foot pounds.
NOTE: Do not tighten if add-on tables
will be attached.
For assembly of add-on tables, see page 2.
Leg bolt Leg bolt
0113 IH-3630