Electrolux EJF5442AOX Instruction Booklet page 30

Refrigerator
HC
comp. too Cold
Low voltage
LOPO
Warning
Check Warnings ;
If your refrigerator does not operate
‡ Is there a power failure?
‡ Is the plug connected to the socket correctly?
‡ Is the fuse of the socket to which the plug is connected or the main fuse blown?
‡ Is there any failure at the socket? To check this, plug your refrigerator to a socket this
is surely operating.
If your refrigerator is operating noisily;
Normal Noises
Crackling (Ice Cracking) Noise
‡ It is heard during the automatic defrosting process.
‡ Once the device has been cooled or heated (expansions in the device material).
Short Cracking Noise: It is heard when the thermostat turns on and off the compressor.
Compressor Noise: It is the normal engine noise. This noise indicates that the compressor
is operating normally. As the compressor is being introduced, it might operate a little bit
more noisily for a short period of time.
Bubbling and burbling sound: 7KLV QRLVH LV HPLWWHG DV WKH FRRODQW ÀXLG ÀRZV WKURXJK
the pipes within the system.
:DWHU ÀRZLQJ VRXQG 7KLV LV WKH QRUPDO VRXQG RI ZDWHU ÀRZLQJ LQWR WKH HYDSRUDWLRQ
container during the defrosting process. This sound may be heard during the defrosting
process performed in the device.
Air blowing sound: It is the normal fan sound. This sound may be heard due to air
circulation in No Frost refrigerators as the system is operating normally.
If the edges of the refrigerator cabin contacted by the door seal are hot;
‡ Especially in summer months (in hot weathers), there might be heating on the surfaces
contacted by the seal on the refrigerator when the compressor is operating and this is
quite normal.
The foods starts to
freeze because of
the too much cold
temperature
When the power supply
gets lower than 170 V
the appliance gets to
steady position.
UK - 28 -
1. Check if the "Super
cooling mode" is on
2. Decrease the
refrigerator temperature
values
This not a failure. This
prevents any damages
on the compressor. This
warning will off after the
voltage gets required
level