Table of Contents
Advertisement
dummyhead
dummyhead
GOVERNOR ADJUSTMENT
Remove the fuel tank (base manual 82Z4100:
page 5-3).
Loosen the 6 mm nut [1] and move the governor arm [2]
to fully open the throttle [3].
Rotate the governor arm shaft [4] as far as it will go in
the same direction the governor arm moved to open the
throttle and tighten 6 mm nut.
Install the fuel tank. Start the engine and allow it to
warm up to normal operating temperature.
Check the engine no load maximum speed. Adjust by
turning the adjusting screw [5] if necessary.
Engine speed (at no load):
SK type (60 Hz):
-1
3,750 ± 150 min
(rpm)
GOVERNOR SYSTEM
[3]
[5]
[4]
[1]
[2]
6-3
Advertisement
Table of Contents
