Kenwood TK-2212 Service Manual page 9

TK-2212/2217
■ Item setting mode flow chart
[1. RX frequency] or
[3. TX frequency]
[S]
MHz setting
[A]
[Selector]
KHz setting
[A]
[Selector]
Channel step
[A]
[Selector]
Frequency clear
[A]
[Selector]
[2. RX signaling] or
[4. TX signaling]
[S]
OFF
[A]
[Selector]
QT
[A]
[Selector]
DQT N
[A]
[Selector]
DQT I
[A]
[Selector]
5. Wide / Narrow
[S]
Wide / Narrow selection
[A]:Not
[S] : Stored
stored
6. RF power Hi / Low
[S]
Hi / Low selection
[A]:Not
[S] : Stored
stored
7. Scan Del / Add
[S]
Del / Add selection
[A]:Not
[S] : Stored
stored
[8. Beat shift on / off] or
[9. Compander on / off]
[S]
on / off selection
[A]:Not
stored [S] : Stored
8
REALIGNMENT
Display
Current
136. 00000
setting value
--------
Value is not set
[<B] / [C>] [S] 136. 00000
[<B] / [C>] [S]
136. 00000
[<B] / [C>] [S]
STP 5.00K
[S] : Cleared
--------
Display
[S] : Tone off
TONE OFF
[<B] / [C>] [S]
QT 67.0
[<B] / [C>] [S]
DQT 023N
[<B] / [C>] [S]
DQT 023 I
[<B] / [C>] Display
Wide Narrow 5.BAND W
[<B] / [C>] Display
Hi Low 6.PWR HI
[<B] / [C>] Display
Del Add 7.SCN ADD
[<B] / [C>] Display
on off 8.SF T ON
9.CMP ON
6. Firmware Version Information
Turn the transceiver ON with the [Side1] and [Side2] keys
held down. Then, the version is displayed during holding the
[Side1] and [Side2] keys.
or