Kenwood TK-2212 Service Manual page 11

TK-2212/2217
Precautions for Reassembly
■ Attaching the battery release lever to the case
assembly.
1. Insert one side of the shaft into the hole at the lever fitting
section on the case assembly
Note: The thin spring (G01-4543-04) should be positioned
above the two tabs of the lever.
2. Tilt the battery release lever slightly forward
thick spring (G01-4542-04) is positioned below the case
surface.
3. With the thick spring positioned below the case surface, attach
the other side of the shaft to the case assembly by pressing
the battery release lever
Note: Be careful not to tilt the battery release lever too
forward.
If the battery release lever is pushed in this state where
the two tabs come below the case surface, there is a
possibility of damaging the two tabs.
Two tabs
A thick spring
■ Assembling the battery release lever
x
1. Place the lever onto the stopper
2. Place the thick spring
3. Hook the right and left ends of the thin spring
tabs of the stopper, then place the thin spring onto the
b
lever .
4. Slide the shaft through the hole of the stopper and lever
4
3
5
2
1
10
DISASSEMBLY FOR REPAIR
z
.
x
, so that the
c v
until it snaps into place
A thin spring
Shaft
2
1
3
z
.
c
onto the lever.
v
onto the
6
■ Attaching the positive terminal to the chassis.
Always attach the positive terminal to the chassis, using
the following procedures, before mounting the TX-RX unit
onto the chassis.
1. Remove the holder assembly
the positive terminal.
2. Mount the packing of the positive terminal into the chassis
c
hole .
3. Mount the holder assembly into the packing of the positive
v
terminal .
2
.
1
■ Mounting the chassis to the case assembly.
1. Confirm that the waterproof packing attached to the
circumference of the chassis is securely inserted in the
4
groove of the chassis
2. Attach the speaker to the speaker recess of the case
x
assembly
Confirm that the
n
.
waterproof packing is
securely inserted in the
groove of the chassis.
3. Insert the upper part of the chassis into the case assembly
c
.
Note: Take care that the speaker lead wire is not caught by
the microphone element.
4. Press the chassis
attach them.
x
from the packing
3
4
z
.
. Make sure the speaker is securely inserted.
2
1
v
and the case assembly together to
z
of