Kenwood TK-2212 Service Manual page 12

Note: If the packing of the SP / MIC does not come to the
correct position after attaching the chassis to the case
assembly, reposition the packing with your fingers.
■ LCD ASSY Installation Procedure
1. Insert the two tabs on the left side of the illumination guide
into the matching slots of the mounting hardware
2. Insert the tab on the right side of the illumination guide into
the mounting hardware using a pair of tweezers
press the illumination guide down until it snaps into place
c
.
3. Ensure that the tab of the illumination guide is fully inserted
into the mounting hardware.
1
1
2
Ensure that the tab of the illumination guide
is fully inserted into the mounting hardware.
DISASSEMBLY FOR REPAIR
3
4
4
z
.
x
, then
3
TK-2212/2217
■ Connecting the speaker wires to the TX-RX unit
1. To connect the speaker wires, solder them to the speaker
terminals of the TX-RX unit
2. Align the speaker wires as shown in figure, making sure to
avoid the legs of the discriminator.
3. Attach the fibrous sheet to the speaker wires as shown by
the silk print on the TX-RX unit
2
Fibrous sheet
legs of the discriminator
■ Attaching the antenna receptacle to the chassis.
Screw the antenna receptacle to the chassis in the order
shown in the drawing so that the antenna receptacle comes
to the center of the case hole.
Tighten this screw first.
Tighten this screw second.
■ The nuts of the volume knob and channel knob
Note that the shapes, colors and heights of nuts of the
volume knob and channel knob are different from one
another. (The nut of volume knob is silver, and the nut of
channel knob is gold)
Use the following jig when removing the nuts of the
volume knob and channel knob.
Jig (Part No. : W05-1012-00)
●
Volume Knob
(Silver)
z
.
x
.
1
SP-
SP+
Silk print
Channel Knob
(Gold)
11