R&G FI0027BK Fitting Instructions

Frame insert for bmw s1000rr

FITTING INSTRUCTIONS FOR FI0027BK FRAME INSERT

BMW S1000RR 2010 LEFT HAND SIDE ONLY

THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW.

DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT.

Please note that the way the kit is packed does not necessarily represent the way of

HE PARTS SHOWN MAY BE REPRESENTATIVE ONLY

M5x25mm LONG COUNTER SUNK BOLT (x1)

BUBBLE

STICKERS

(x4)

Please note that in cases where kits are packed with rubber washers holding the components onto the bolt –

Unit 5K, Blacknest Industrial Park, Blacknest Road, Alton, Hampshire, GU34 4PX

Tel: +44 (0)1420 521100 Fax: +44 (0)1420 521101

mounting to the bike

the rubber washers should be thrown away!

R&G Racing

www.rg-racing.com

(

FOR CLARITY OF INSTRUCTIONS ONLY

FRAME INSERT (FI0027) (x1)

Email:

info@rg-racing.com

)

SPECIAL

NUT

(H0035) (x1)

Table of Contents

Do you have a question about the FI0027BK and is the answer not in the manual?

Page 1 FITTING INSTRUCTIONS FOR FI0027BK FRAME INSERT BMW S1000RR 2010 LEFT HAND SIDE ONLY THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW. DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT. Please note that the way the kit is packed does not necessarily represent the way of...
Page 2 TOOLS REQUIRED • 3mm metric Allen key. Left-hand side (as you sit on bike) • Fit the counter sunk headed bolt through frame insert so head sits in counter-sink. • Place special nut on exposed end of bolt so tapered face goes into tapered recess. •...