Table Of Contents - Q5X QT-AD10 Series User Manual

TABLE OF CONTENTS

___________________________________________________________________________________
1.0 INTRODUCTION ...................................................................................................................................
1.1Transmitters
1.2 Remote Control Audio System (RCAS)
1.3 Handheld MicCommander (QG-H2)
1.4 Network GateWay (QG-N3)
1.5 MicControl
1.6 Microphone
2.0 POWER MANAGEMENT......................................................................................................................... 2
2.1 Charge
2.2 Storage mode
2.3 Standby mode
2.4 ON mode
3.0 MICCOMMANDER..................................................................................................................................... 3
3.1 Start-up
3.2 Settings
Frequency, power, battery, mic, mic off-set, name, group
o
RF power, 2.4 GHz channel, storage mode, reboot, main menu
o
3.3 Active Transmitters List
Transmitters - status & control
o
Adding and removing transmitters from transmitter list
o
Linking, LED flash, sorting of active transmitter list
o
3.4 Group commands
3.5 Device configuration (link id, 2.4ghz channel, default channel, channel selection, LCD contrast)
3.6 Tools (2.4GHz spectrum, diagnostics, LED flashing)
4.0 RECEIVER .............................................................................................................................................. 7
4.1 Transmitter telemetry
4.2 Encryption
4.3 Transmission modes
4.4 IR sync
5.0 SPECIFICATIONS ..................................................................................................................................
5.1 Input connector diagram
5.2 Frequency bands and transmitter RF power
6.0 LICENCING INFORMATION ................................................................................................................
6.1 Licensing
6.2 Certifications
7.0 FIRMWARE UPDATES .........................................................................................................................
7.1 QT-AD10 Firmware
7.2 Versioning
7.3 Updating the transmitter
8.0 APPENDICIES - QUICK START GUIDES .............................................................................................. 10
1
8
9
9