Q5X QT-AD10 Series User Manual page 16

This Quick Start Guide is an overview. Users are asked to
review the manual for detailed instructions. The carrying
pouch contains two parts:
Digital PlayerMic transmitter (QT-AD10P or PS)
•
Micro USB charging cable
•
Users also need:
Q5X Gateway (remote control)
•
Handheld MicCommander (QG-H2) or
o
Network Gateway (QG-N3)
o
Shure Axient Digital receiver
•
Microphone (1-pin Lemo connector)
•
Visit www.Q5X.com/support to:
update the firmware
•
register the warranty
•
download the manuals
•
KEY:
1 2.4 G antenna - For the RCAS control channel.
2 Audio input - Connects to a microphone with a one-
pin Lemo connector.
3 UHF antenna - For RF signal transmission.
4 Serial number - Unique serial number for RCAS
identification and control. (on the antenna)
5 IR port - Infrared sync with the receiver for set-up,
initiating encryption and installing firmware updates.
6 Status LED (See manual for details on LED patterns
and colours.)
7 Charge LED - Red = charging, green= charged and
flashing red/green = error.
8 USB port - Charges the battery.
9 On/Off button - Manual power control between on,
standby and storage modes.
BATTERY LIFE:
PlayerMic S 4 hrs @ 2/10mW
PlayerMic 8 hrs @ 2/10mW
For an updated copy of this document, visit www.Q5X.com/support
2 hrs @ 20mW
4 hrs @ 20mW
PREPARE:
PlayerMic Transmitter
Bring the transmitter out of storage mode (minimal
•
battery draw) and into standby mode (detectable but
the UHF radio is off) using either method below:
Hold the ON/OFF button until the status LED
o
changes from flashing rapidly to slowly, or
Plug and unplug a powered micro USB charging
o
cable into the side of the transmitter.
Connect the 1-pin Lemo microphone
•
PREPARE:
Gateway remote control (H2 or N3)
Install the antenna on the top. (NEVER power the
•
unit without the antenna in place.)
Power the Gateway as instructed in its manuals.
•
Turn on the unit by pressing the power button.
•
PAIR:
PlayerMic and Gateway remote control (H2 or
N3)
The screen on the Gateway displays the serial
•
number of paired transmitters.
Press the <MENU> button to either scan for
•
transmitters or add the serial number found on the
PlayerMic antenna.
ADJUST
:
Set the functions in the two transmitter
menus of the Gateway. Screen one includes frequency,
power On/Off, battery level, mic mute/live and mic
offset. Screen two includes: transmitter name, group, RF
power, 2.4GHz channel, storage and reboot.
IR SYNC:
Use IR Sync to form an audio channel
between the transmitter and receiver. The receiver band
must match the band of the transmitter.
Select a receiver channel.
•
Tune the channel to an available frequency using
•
group scan or manually tune to an open frequency.
Assure transmitter is in standby or ON mode.
•
Press the SYNC button on the receiver.
•
Align the IR windows between the transmitter and
•
the receiver so that the IR LED illuminates red.
When complete, "Sync Success!" appears on the
•
receiver.
USE TIPS
:
When using the PlayerMic, it is suggested
that a strain relief method be used to ensure that there
is no direct pulling force on the microphone connector
during use or during removal. One method is to loop the
microphone cable back and tape the connector to the
edge of the transmitter.
13 | P a g e