Licencing Information; Licensing; Certifications; Firmware Updates - Q5X QT-AD10 Series User Manual

Q5X USER MANUAL: QT-AD10 TRANSMITTER FAMILY
___________________________________________________________________________________
6.0 LICENSING INFORMATION
6.1 LICENCING
A ministerial license to operate this equipment may be required in certain areas. Consult your national authority for
possible requirements. Changes or modifications not expressly approved by Q5X could void your authority to operate the
equipment. Licensing of Q5X wireless microphone equipment is the user's responsibility, and licensability depends on the
user's classification and application, and on the selected frequency. Q5X strongly urges the user to contact the appropriate
telecommunications authority concerning proper licensing, and before choosing and ordering frequencies.

6.2 CERTIFICATIONS

Certified under FCC Part 15, Subpart C, section 15.247 and Part 74 FCC ID: Q5N-QTAD10A and FCC Part 15, Subpart C,
section 15.247 and Part 74 FCC ID: Q5N-QTAD10C
Certified by ISED in Canada under RSS-210 and RSS-247 IC:4614A-QTAD10A
RSS-123 and RSS-247 IC:4614A-QTAD10C
Meets essential requirements of the following European Directives:
• WEEE Directive 2012/19/EU, as amended by 2008/34/EC
• RoHS Directive EU 2015/863
NOTE: Note: Please follow your regional recycling scheme for batteries and electronic waste
This product meets the Essential Requirements of all relevant European directives and is eligible for CE marking.

7.0 FIRMWARE UPDATES

7.1 QT-AD10 FIRMWARE

Firmware is embedded software in each component that controls functionality. Periodically, new versions of firmware are
developed to incorporate additional features and enhancements. To take advantage of design improvements, you can
download and install new versions of the firmware from the Q5X website

7.2 VERSIONING

When performing an update, first download firmware to the receiver, and then update transmitters to the same firmware
version to ensure consistent operation. Shure Axient Digital receiver firmware can be updated using the Shure Update
Utility. The Shure Update Utility is available for download from http://www.shure.com/. The firmware numbering for
Shure devices uses the following format: MAJOR.MINOR.PATCH (e.g., 1.2.14). At a minimum, all devices on the network
(including transmitters), must have the same MAJOR and MINOR firmware version numbers (e.g., 1.2.x).

7.3 UPDATING THE TRANSMITTER

1. Download the firmware to the receiver.
2. Access the following menu from the receiver: Device Configuration > Tx Firmware Update.
3. Ensure that the QT-AD10 transmitter is I the ON mode (not Standby). Align the IR ports between the transmitter
and the receiver. IR ports must be aligned for the entire download, which can take 50 seconds or longer. Tip: The
red alignment LED will turn on when the alignment is correct.
4. Press ENTER on the receiver to begin the download to the transmitter. The receiver will display the progress of
the update as a percentage.
___________________________________________________________________________________
For an updated copy of this document, visit www.Q5X.com/support
www.Q5X.com/support
JUNE 2020
9 | P a g e