Disassembly For Repair - Kenwood TK-3000 K Service Manual

TK-3000
1. Separating the Case Assembly from the
Chassis
1. Remove the two knobs ( a ).
2. Remove the two screws ( b ).
3. Expand the right and left sides of the bottom of the case
assembly, Iift the chassis, and remove it from the case
assembly ( c ).
b
b
c
4. Taking care not to cut the speaker lead ( d ), open the
chassis and case assembly.
Note:
Solder the speaker wire back in its original position if you
have removed it.
–
+
6

DISASSEMBLY FOR REPAIR

a
a
d
BRN
GRN
2. Removing the TX-RX unit from the
Chassis
1. Remove the packing ( e ).
2. Remove the 13 screws ( f ).
3. Remove the packing ( g ) and two hexagon nuts ( h ).
4. Remove the solder from the antenna terminal using a
soldering iron then lift the unit off ( i ).
Note:
When reassembling the unit in the chassis, be sure to
solder the antenna terminal.
f
3. Removing the Rear Panel
1. Raise the rear panel on the chassis ( j ).
j
i
Antenna terminal
g
h
h
e