Raise Lift Device; Align Wheels; Push Device Off The Forklift; Operating The Overhead Lifting Device - ABB Emax Link 2 UR 1558 Application Manual

Abbreviated low voltage, metal-enclosed, drawout switchgear

Table of Contents

E M A X L I N K 2 A B B R E V I AT E D LV S W I TC H G E A R A P P L I C AT I O N G U I D E

—

Installation guidelines

4. After mating all locator plates in place with the

rails, secure the locator plates and the rails.

5. Position overhead lift device on the tines of

forklift. Raise the overhead lift device up to the

rails on the frame.

Raise lift device

Align wheels on the front rail and behind the rear

rail. Adjust the upper-rear wheel to minimize

vertical movement.

Push the overhead lift device off the forklift onto

the rails.

Test the continuous movement of the overhead lift

device. If the movement is correct, reinstall the

carriage stop bracket.

Observe the following requirements when

operating the circuit breaker lifting device:

• The wheels must be properly set on track.

• Do not depend upon the drum attachment to

support the full breaker weight.

• Allow 4-5 wraps of wire rope to remain on

the drum.

• Prevent snarling, kinking or knotting the

wire rope.

• Lift only circuit breakers.

• Do not alter the lifting device or the circuit

breaker lifting yoke.

• Never walk or stand under a suspended breaker.

• Do not leave a circuit breaker suspended.

Table of Contents