Operation And Settings; Control Panel And Remote Control Description - Levita AC 12000 Maintenance And User Manual

OPERATION AND SETTINGS

Control panel and remote control description

1. Control panel commands
Control description:
❶
1. Timer button
2. Fan speed adjustment button
3. Arrow up button
4. Display
• When starting the air conditioning unit for the first time, the buzzer will play the initial
sound and then the air conditioning unit will go to a standby mode.
• Push button: The air conditioning is switched on and off using this button. If the air
conditioning unit is on, press this button to turn it off. If the air conditioning unit is off,
press this button to turn it on.
• Mode selection button: If the air-conditioning unit is switched on, you can toggle
between the modes: cooling -> fan -> dehumidification.
• Arrow up/down buttons: Pressing these two buttons allows you to change the
temperature or time settings as follows:
Set the required temperature by pressing the up/down arrow button (not available in
the fan or dehumidification mode). Set the required time by pressing the up or down
arrow button.
• Fan speed adjustment button:
1) In the cooling and fan modes, you can press this button to set the high or low fan speed
and thus the air flow rate. However, this function is limited under certain conditions,
such as antifreeze, and may not run at the pre-set speed.
2) In the dehumidification mode, pushing of this button is ineffective and the fan is forced
to run at the low operating speed.
• Timer button:
If the air conditioning unit is switched on, push this button to switch off the time
measurement. If the air conditioning unit is switched off, push this button to switch on
the time measurement.
Push this button until the timer symbol starts flashing, then push the up / down arrow
buttons to set the time value.
Time can be set in the range of 1 to 24 hours with a step of 1 hour.
❷ ❸ ❹ ❺
5. Arrow down button
6. Mode selection button
7. Push button
8
❻ ❼