Table of Contents
Advertisement
3.2. Overflow protection control:
When the water level in the water reservoir exceeds an alarm level, the air
conditioning unit gives an acoustic warning signal and the 'WATER FULL' indicator
starts flashing. In this case, connect the drain hose to the outlet of the air-
conditioning unit, put the other end into the waste or a collection container and
drain water from the air-conditioning unit (see the Drainage instructions). After
draining the water, the air conditioning unit returns to its original operating state.
3.3. Automatic defrosting (this is only available on the models with the cooling
function): The air conditioning unit is equipped with an automatic defrosting
function. Defrosting is carried out using a four-way reverse valve.
3.4. Compressor protection:
In order to extend the service life, the compressor is equipped with a protective
function of a three-minute delay of restarting the compressor after it has been
switched off.
Installation and positioning
1. Installation:
Warning: The mobile air conditioning unit should be left standing upright for at least two
hours before starting.
The air conditioning unit can be easily moved around the room. When moving, the air
conditioning unit should be placed on a flat surface in a vertical position. Do not place or use
the air conditioning unit in bathrooms or other wet areas.
1.1
Installation of the hot air outlet piping assembly (see Fig. 1)
1) Unpack the connector and the outlet pipe assembly from the package and remove them
from the plastic bags.
2) Insert the outlet pipe assembly (the end of the outlet connector) into the groove of the
ventilation hole in the rear panel of the air conditioning unit (push to the left) and
complete the assembly as shown in Fig. 1.
Fig. 1
10
Advertisement
Table of Contents
