Advertisement
WARNING! This product contains (a) small magnet(s). Swallowed magnets
can stick together across intestines, causing serious infections and death. Seek
immediate medical attention if magnet(s) are swallowed or inhaled.
Cautionary and Warning Statements
•
This kit is designed and intended for educational purposes only.
•
Use only under the direct supervision of an adult who has read and
understood the instructions provided in this user guide.
•
Read warnings on packaging and in manual carefully.
•
Always exercise caution when using sharp tools.
Materials Included
•
Precut chassis (card stock)
•
2 sail masts (dowels)
•
4 magnets
Items Required (not included)
•
Maglev Track or Maglev Track II
•
Magnetic Pole Identifier (optional)
•
Low-velocity fan or hair dryer
•
Copy or construction paper
•
White correction fluid or a white pencil or pen (optional)
Mag Sailer
•
•
•
•
•
User Guide
4 adhesive tabs
6 O-rings
Scissors
Hole punch
Cool-melt glue gun and glue
Car
60074 V0113
Advertisement
Table of Contents
Related Manuals for pitsco Mag Sailer Car
Summary of Contents for pitsco Mag Sailer Car
- Page 1 Mag Sailer User Guide 60074 V0113 WARNING! This product contains (a) small magnet(s). Swallowed magnets can stick together across intestines, causing serious infections and death. Seek immediate medical attention if magnet(s) are swallowed or inhaled. Cautionary and Warning Statements • This kit is designed and intended for educational purposes only.
- Page 2 Figure 4 The track’s magnets should repel the magnets on the chassis (Figure 4). If any of the four magnets are attracted to the track, remove the magnet from the chassis, flip it over, and reattach Figure 5 Figure 6 it on the other side so it repels the strip. Now, the chassis should float (levitate) over the track. Remove from the track. Mag Sailer Car User Guide 60074 V0113...
- Page 3 Figure 8 and bottom as shown on the pattern. 9. Place an O-ring over a sail mast and push it down so it’s about 1" (2.54 Sail cm) above the chassis. Thread a mast O-rings through the hole at the narrow end of the sail. Then, thread the mast through the hole at the wide end. Place an O-ring on top of the sail and push it down a bit so the sail has a bend to catch the air (Figure 9). Repeat if using two sails. Figure 9 Mag Sailer Car User Guide 60074 V0113...
- Page 4 Figure 11 • On two-sail cars, try angling the sails in different directions (Figure 11). How does it perform compared to when the sails face the same direction? P.O. Box 1708 • Pittsburg, KS 66762 www.pitsco.com Toll-Free Orders 800-835-0686 Mag Sailer Car User Guide 60074 V0113...
Need help?
Do you have a question about the Mag Sailer Car and is the answer not in the manual?
Questions and answers