Table of Contents
Advertisement
Axis Rack Mounted Video Server Solution
Axis Blade Video Server
Bus Connector -
Physical interface to the I/O Block Connector on the rack
DIP Switch(es) - A corresponding line termination switch for each of the supported video
outputs (1-4 video outputs depending on the model).
• All units are shipped with the line ter-
mination enabled for each supported
video input; that is, with the DIP
switches set to ON. (Down position)
• If the AXIS Video Server is to be con-
nected in parallel with other equip-
ment, disable the input termination by
setting the corresponding DIP switch
to OFF (Up position). Failure to do this
can cause the picture quality to be
impaired
Axis Video Server Rack
DC - Power
(GND)
Power
connector
DC + Power
The I/O Terminal Block - the physical interface to a relay switch output, four digital
photo-coupled inputs; providing also an RS-485 interface and an RS-232 serial
connection.
Network Connector - Axis blade video servers are designed for 10 Mbps Ethernet /100
Mbps Fast Ethernet networks and connect to the network via a standard RJ 45 connector.
DC + Power 12VDC Power (output) - This connector can drive the photo coupler inputs
or other equipment such as an IR-sensor. A maximum current (for all pins) of 1000mA can
be sourced from the DC output.
Power Connector -
Input power: 100-240 VAC, 50-60 Hz, 1.6A
Dip Switch(es)
Bus
Connector
I/O Terminal Blocks
Network Connectors
5
Advertisement
Table of Contents
