Toro 140-8016 Installation Instructions Manual page 3

2
Removing the Existing
Blades
No Parts Required
Procedure
Remove the existing blades from the spindles; refer
to the Operator's Manual.
3
Removing the Existing
Baffles
No Parts Required
Procedure
Note:
In the steps below, the bolts are threaded
into the mower deck. Remove the nuts first before
removing the bolts.
1. Remove the cam locks, washers, nut, and bolt
from the adjustable flow baffle
2. Remove the bolts and nuts securing the left
baffle (Figure 1).
3. Remove the bolts and nuts securing the
discharge baffle (Figure
Note:
Retain the baffles and hardware for use
when changing to side-discharging mode.
(Figure 1).
1).
72-inch deck shown
1. Cam lock
2. Washer
3. Locknut
4. Left, front baffle
3
Figure 1
5. Bolt
6. Right adjustable flow baffle
7. Discharge baffle
g316018