Advertisement
Procedure
7
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Preparing the Machine
No Parts Required
Procedure
Perform the following procedure to prepare the machine for attaching the blower and finishing kit.
1.
Disengage the PTO, move the motion-control levers to the N
brake.
2.
Shut off the engine, remove the key, and wait for all moving parts to stop before leaving the operating
position.
3.
Repair all bent or damaged areas of mower deck and replace any missing parts.
4.
Clean the machine of any debris on the deck or rear part of the machine to ease installation.
Description
Kicker
Bolt (3/8 x 1 inch)
Locknut (3/8 inch)
Qty.
1
Install the kickers (for 72-inch decks
4
only).
4
-
EUTRAL
LOCK
2
Use
position, and set the parking
Advertisement
