Waterous AQUIS ULTRAFLOW Installation And Operation Manual page 8

Safety Introduction
AQUIS ULTRAFLOW Industrial Foam Proportioner System
Subsystem Subsystem
4 Concentrate pump
5 Concentrate supply
6 Concentrate supply refill line
Product Overview
Description Description
These components support, control, and power the concentrate pump. The components in this subsystem include:
• Concentrate pump—this circulates the foam concentrate through the system.
• Hydraulic motor—this drives the concentrate pump.
• Hydraulic pump—this drives the hydraulic motor.
• Hydraulic fluid reservoir—this contains the hydraulic fluid supply.
• Hydraulic fluid filter—this filters the hydraulic fluid.
• Hydraulic fluid heat exchanger—this cools the hydraulic fluid.
• Hydraulic fluid temperature sensor—this measures the hydraulic fluid temperature.
• Hydraulic fluid level sensor—this monitors the hydraulic fluid level in the reservoir.
• Pressure transducer—this measures the pressure in the concentrate discharge line.
• Pressure relief valve—this limits the pressure in the concentrate discharge manifold by opening when the pressure
reaches a predetermined level.
This contains components that contain or supply foam concentrate for the system. The components in this subsystem
include:
• Concentrate supply tank—this contains the on-board foam concentrate supply.
• Tank-full sensor—this indicates a tank full condition to the system.
• Tank-low sensor—this indicates a tank low condition to the system.
• Tank level sensor—this is an installer supplied sensor and display that indicates the supply level in the tank.
• Concentrate pump intake select valve—this is an installer supplied, 2 position valve, and additional components that
sources concentrate from an on-board tank or an auxiliary supply. A signal is provided to the system to ignore the
on-board tank sensors when sourcing concentrate from an auxiliary supply.
• Concentrate strainer—this collects debris that would otherwise flow through the system and could damage the
concentrate pump.
This allows you to fill the on-board tank from an external source. The components in this subsystem include:
• Node controller—this connects to the fill valve and flowmeters.
• Fill line control valve—this controls the flow of concentrate.
• Magnetic flowmeter—this measures the flow of concentrate.
• Split CANbus cable—this connects the node controllers to one another and the control box.
• Check valve—this prevents reverse fluid flow in the line.
Installation
|
8 56
Operation Maintenance