Operation; Powering Up The Display - Waterous AQUIS ULTRAFLOW Installation And Operation Manual

Safety Introduction

Powering Up the Display

Product Overview
1
3
#1 / #2
PASSENGER 6"
PASSENGER 2~1/2"
DECK GUN 8"
#1 / #2 DRIVER
DRIVER 6"
2~1/2"
#1 / #2 PASSENGER 2~1/2" PASSENGER 6"
111.2 3708 89.2
37.5
11.3 375
DECK GUN 8"
FRONT / REAR CROSSLAY 1~3/4"
298.5 9950 136.9
75 2500 3
#1 / #2 DRIVER 2~1/2"
DRIVER 6"
524.7 17491 151.1
11.3 375 37.5
< SOLUTION
|
37
Installation
Use the illustrations and instructions to monitor the
2
start-up as the system comes online. The display
powers-up automatically with the pump panel.
1 This is the first start-up screen. This screen
indicates that the display is receiving power and
the boot sequence has initiated.
2 This screen displays as the Tellurus begins to
communicate with the PLC.
Note: The operating system and the software
3 A pulsating ring animates as the Tellurus and
PLC communicate.
4 Once the start-up sequence is complete the
system displays the gauge screen.
Note: All the screens described in this section are
4
REAR PASSENGER
2~1/2"
FRONT / REAR
CROSSLAY 1~3/4"
REAR DRIVER /
DECK GUN 5"
REAR PASSENGER 2~1/2"
2972 603 20102
1250 11.3 375
REAR DRIVER / DECK GUN 5"
4563 306 10201
100 30 1000
5038
1250
SYSTEM >
56

Operation

Maintenance
versions are displayed in the lower
corners.
configurable to your specific application.
The appearance of your screen may differ
than what is illustrated. The illustrations in
this section are based on the 15-inch HMI.
The 8-inch HMI displays the lower 2/3 of
the 15-inch HMI—omitting the apparatus
graphic and discharge locations. Apply the
concepts described in the instruction to your
application. Contact Waterous for more
information.