Record Your Own Announcement; Number Of Rings - AT&T CLP99287 Quick Start Manual

Initial basic settings
6. Turn on the Bluetooth feature of your cell phone and search for or add new
advices. Once your cell phone finds your AT&T phone (AT&T DECT 6.0), press the
appropriate key on your cell phone to continue the pairing process.
7.
To pair and connect a headset using the telephone base:
MENU
1. -> /
SELECT to select Add device.
2.
-> Add headset -> SELECT.
3. /
4. Disconnect the headset from any Bluetooth device -> Press NEXT.
5. Set your headset to discoverable mode -> Press NEXT.
6. Press /

Record your own announcement

Your outgoing announcement plays when calls are answered by the answering
system. You can use the preset announcement to answer calls, or replace it with
your own recorded announcement.
Using a cordless handset or the telephone base:
1. MENU -> /
SELECT to select Announcement.
2.
SELECT to select Record annc.
3.
4. Speak towards the handset or telephone base to record your announcement
STOP
and press

Number of rings

You can set the answering system to answer an incoming call after 2, 3, 4, 5, or 6
rings. You can also select toll saver. If you choose toll saver, the answering system
answers a call after two rings when you have new messages, or after four rings
when there are no new messages. This enables you to check for new messages and
avoid paying unnecessary long distance charges if you are calling from out of your
local area.
Using a cordless handset or the telephone base:
MENU
1. -> /
2. / -> Ans sys setup -> SELECT.
-> # of rings -> SELECT.
3. /
4. / to choose among 2, 3, 4, 5, 6, or Toll saver -> SELECT.
-> Bluetooth -> SELECT.
to choose your headset, if required -> Press SELECT.
-> Answering sys -> SELECT.
to end recording and save it.
-> Answering sys -> SELECT.
13