Axis 215 PTZ Installation Manual page 8

Page 8
6. Adjust the length of the
supplied safety wire and attach
it to both the inner bracket and
the hard ceiling above the drop
ceiling.
7. Connect the camera to the
network using a shielded
network cable.
8. Optionally connect external
input/output devices, e.g.
alarm devices. See page 16 for
information on the terminal
connector pins.
9. Optionally connect an active
speaker and/or external
microphone.
10. Connect the supplied indoor
power supply to the power
connector on the camera.
11. Lift and turn the inner bracket
(with camera) so that the
screws on the outer bracket
enter the screw slots on the
inner bracket. Make sure that the screws go all the way to the back of the slots.
12. Gently tighten the screws so that the ceiling tile is held between the inner and outer
brackets. Check that none of the cabling is trapped by the brackets.
Note:
When power is applied, check that the indicator LEDs indicate the correct conditions.
See the table on page 17 for further details.
Align slots
with screws
AXIS 215 PTZ Installation Guide
Safety wire
M4x4 screw