Network - Socks; Network - Smtp (Email); Network - Upnp; Rtp/Mpeg-4 - Axis 213 PTZ User Manual

AXIS 213 - System Options
46

Network - SOCKS

SOCKS is a networking proxy protocol. The AXIS 213 can be configured to use a
SOCKS server to reach networks on the other side of a firewall/proxy server. This
functionality is useful if the AXIS 213 is located on a local network behind a firewall,
but notifications, uploads, alarms, etc., need to be sent to a destination outside the
local network (e.g. to the Internet).

Network - SMTP (email)

(Simple Mail Transfer Protocol) Enter the host names or addresses for your primary
and secondary mail servers in the fields provided to enable event and error email
messages from the AXIS 213 to predefined addresses, via SMTP.

Network - UPnP

The AXIS 213 includes support for UPnP in Windows Millennium and Windows XP.
UPnP is enabled by default.
Note:
UPnP must be installed on your workstation. To do this, open the Control Panel from the Start Menu
and select Add/Remove Programs. Select Add/Remove Windows Components and open the Net-
working Services section. Click Details and then select UPnP as the service to add.

RTP/MPEG-4

Multicast must be enabled for these settings to take effect. The settings are only valid
when MPEG-4 is used as the video format. These settings are the port range, IP
address, port number, and Time-To-Live value to use for the video stream(s) in
MPEG-4 format. Only certain IP addresses and port numbers should be used for
multicast streams.
Enter the port range, IP address and the port number to use for the video and audio
streams in the required fields.
Only IP addresses within certain ranges can be used for multicasting. The camera has
been pre-configured with an address from these ranges, and this does not normally
need to be changed. Please contact your network administrator if you have special
requirements.