Table of Contents
Advertisement
2. Assembly/installation
When unpacking, check that no parts are damaged. If any damage is found, contact Care of Sweden or your local distributor
before using the product.
1. Place the mattress on the bed
base. Secure the mattress to
the bed using the fastening
straps on the underside of the
mattress.
Note:
•
Make sure that the mattress is the correct size for the
bed.
•
Make the bed with sheets for added comfort.
•
If an adjustable bed is used the mattress should be fixed
only to the moving parts of the bed.
•
Check the cells and press studs to ensure they are
correctly assembled.
2. Hang the control unit on the
foot end of the bed or place it
on a level, steady surface.
3. Place the power cable in the
cable holder by opening the
press studs, placing the cable
in the gap and closing the press studs again. If the cable
holder is not used: place the power cable so there is no risk
of stumbling over it, running over it with the bed wheels, or
getting it jammed when raising or lowering the bed.
4. Open the lid on the air tube
connector (marked 'CPR') and
connect it to the side of the control unit.
5. A click is heard and felt
when correctly connected.
Secure that both sides of
the connection are closed.
6. Check that the switch on
the side of the control unit
is set to '0' (off). Plug the
power supply into an approved
electrical socket (100– 240 V).
7. Check that the power cable
has been correctly connected
to the control unit and that the
correct power supply has been
used. (See section 9.1 Technical
specification).
The correct P/N must be shown on the label on the power
supply. The power supply is part of the equipment and may
not be replaced.
If the control unit has been stored in its minimum or
maximum storage temperature (-25°C to 70°C), wait at least
1 hour before starting it. This time is based on an ambient
temperature of 20°C.
.
NOTE:
Do not hold the 12 V plug on the power supply while touch-
.
ing the user.
Plug the power supply into an easily accessible socket if
there will be a need to unplug the power supply and com-
pletely cut the power to the control unit.
6
Hide quick links:
Advertisement
Table of Contents
