Table of Contents
Advertisement
❑ ❑ ❑ ❑ Positioning adjustments
After checking alignment of the feeder with either the
thread or the bar, any required corrections should be
carried out.
Adjust height by turning the screws in the support feet;
carry out lateral adjustment with calibrated mallet
blows on the sides of plates E.
During this phase, any adjustment carried out during
levelling should be preserved; therefore, in most cas-
es, feeder positioning will be the result of a good ad-
justment compromise.
4.4.6 Feeder fastening
B
34.043 Ec. 0
❑ ❑ ❑ ❑ Fastening to the lathe
Wherever possible, the feeder should be fastened to
the lathe through the suitable coupling unit according to
lathe make and type. The figure shows a general ex-
ample of fastening; contact IEMCA service department
for more information.
HANDLING AND INSTALLATION
E
34.042 Ec. 0
❑ ❑ ❑ ❑ Ground fastening
•
Drill the floor and fix the backing plates with expan-
sion plugs.
•
Fix the feeder to the plates through the tie-rods A and
lock with nuts B.
•
Perform another levelling and alignment check.
•
Remove all the equipment used for levelling and
alignment and restore initial feeder conditions.
A
34.044 Ec. 0
35
4
302.034
Advertisement
Table of Contents
