Opening Dimensions - Sub-Zero DEU2450R Design Manual

Specifications

Opening Dimensions

DESIGNER SERIES UNDERCOUNTER MODELS
24"
OPENING
1
34 / "
2 (876)
OPENING
HEIGHT
SIDE VIEW
1
NOTE: 3 / " finished returns will be visible and should be finished to match cabinetry.
(89)
2
3
/ "
4 (19)
TYPICAL
1
3 / "
2 (89)
FINISHED
RETURN
24"
(610)
FRAMELESS
CABINETRY
The depth of each model is 23 1/8"
thickness when planning the finished opening depth. A
minimum 3 1/2" finished return is required on all sides of
(89)
the opening. Framed cabinets require additional finished
filler material behind the face frame for a proper installa-
tion. Refer to the illustration above.
(610)
DEPTH
TOP VIEW
24"
(610)
OPENING WIDTH
FRONT VIEW
3
/ "
4 (19)
TYPICAL
1
3 / "
2 (89)
FILLER
FINISHED
RETURN
24"
(610)
FRAMED
CABINETRY
. Allow for panel
(587)
DUAL INSTALLATION
If two units are installed side by side, a dual installation kit
may be required. Installations without a custom filler strip
require a dual installation kit. If a dual installation kit is not
specified, a 2" filler strip is recommended between the
(51)
units. Dual installations without a filler strip can only be
accomplished using two units with opposite hinges. Refer
to the illustrations below.
IMPORTANT NOTE: For dual installations of a door and
drawer model, the door model face frame is approximately
1/16" proud of the drawer face frame. This is only appar-
(2)
ent when the door/drawers are open at the same time.
The door/drawers align when closed. The door handle
must be next to the drawers.
Dual installation kits are available through an authorized
Sub-Zero dealer. For local dealer information, visit the
find a showroom section of our website, subzero.com.
For questions regarding the installation, call Sub-Zero
Customer Care at 800-222-7820.
DUAL OPENING WIDTH
Two 24" Models
Dual installation kit required.
WITHOUT FILLER STRIP
Opposite hinges
W
48"
(1219)
FILLER STRIP
Same side hinges
subzero.com | 5