Amway eSpring Owner's Manual page 18

COM P LETING IN STAL LATION
1. Replace the Electronic Module
(Fig. 19C)
2. Push cord strain relief into notch
on Base Housing (Fig. 20C).
NOTE; Make sure the tubes are in the
notches on the back of the Base Housing.
3. Store the removal tool for future
use (Fig. 21C).
16
Fig. 19C
Fig. 20C
Fig. 21C
4. Place the Top Shroud over onto
Base Housing (Fig. 22C).
5. Plug the Power Adapter into the
wall outlet (Fig. 23C).
TM
NOTE: eSpring Water Purifi er needs to
be plugged into an outlet with continuous
power.
6. Wait for monitor to signal new
Cartridge with a beep. This may
take 30 seconds.
7. Turn on water to the Water Purifi er
and make sure that the display has
a blue cup (p. 11). If not, refer to
Troubleshooting, Auditory Warn-
ings (p. 13).
Fig. 22C
Fig. 23C