Amway eSpring Owner's Manual page 11

6. Remove the Top Shroud (Fig. 9B).
7. Remove the Electronic Module
(Fig. 10B).
8. Insert the green and blue tubes
attached to the Auxiliary Faucet
into their proper locations on the
Bracket (Fig. 11B & 12B).
NOTE: You may feel resistance before
the tubes are fully installed. Ensure the
tube is fully pushed in until it meets the
mark or the marks disappear as a check
on each of the tube connections in steps
8 -10.
Fig. 9B
Fig. 10B
Fig. 11B
Fig. 12B
9. Connect the tube from the cold
water supply to the screen side of
the Connector (Fig. 13B).
NOTE: You must use the supplied Connec-
tor with fl ow controller (Fig. 2, part c)
between the valve at the water supply
and the eSpring™ Auxiliary Faucet.
10. Insert the red tube attached to
the Auxiliary Faucet into the
opposite end of the Connector
(Fig. 14B).
11. Open the Auxiliary Faucet (Fig. 15B).
12. Open the water supply shut-off
valve to start water fl owing
through the Water Purifi er.
NOTE: It will take a short time for water
to saturate the Cartridge and fl ow from
the faucet. Flush for 5 minutes to remove
air pockets and carbon dust. It may take
5-15 minutes to clear.
13. Turn off the Auxiliary Faucet
and check for any signs
of leakage at all tubing
connections (Fig. 16B). If
there is leaking or bubbling,
refer to Troubleshooting in
the manual (p. 12).
Fig. 13B
Fig. 14B
Fig. 15B
Fig. 16B
9