Amway eSpring Owner's Manual page 10

PR EPAR ING F OR INSTAL L ATI O N
1. a. Lay the red tube and the
green tube on the top of the
diagram one at a time. Lay
the blue tube on the bottom
and use a pen to mark them
at the arrows (Fig. 3B).
b. Use a ruler or lay the tube
from the cold water supply
on the top of this diagram
and mark a line at 3 ⁄ "
4
(18mm) or at the arrow
(Fig. 3B).
2. Select a location for the
Auxiliary Faucet. There may already be an extra, capped hole in your sink's
ledge for a sprayer, soap dispenser or extra faucet that can be used for
mounting your Auxiliary Faucet. If you are removing the connected sprayer,
it will need to be sealed properly. (See local plumbing store for assistance.)
3. If you need to drill a new hole, it must be between 1 ¼" (32mm) and 1
(38mm) in diameter, less than 5
at least 1 ¼" (32mm) from the wall. Before drilling, make sure that you
have suffi cient clearance below the sink or countertop to accommodate the
faucet and allow you to make connections to the eSpring™ Water Purifer.
NOTE: For solid countertops it is recommended to use a very sharp bi-blade hole
saw and start by making a pilot hole. If you have a porcelain/ceramic sink or a tile
countertop, it is recommended to seek professional assistance for proper drilling.
WARNING: Due to the possibility of shock or electrocution, use extreme care
when operating an electric power drill or other power tools around the sink.
Make sure that no part of you or the drill comes into contact with water or
moisture at any time.
8
Fig. 3B
3 ⁄ "( )
4
⁄ "( )
5
8
1 ⁄ " (140 mm) from the sink basin and
2
I NS TALL ING T H E FA U CE T
1. Remove the caps from both ends
of the spout. (Fig. 4B).
2. Press faucet spout into the main
body (Fig. 5B).
1 ⁄ "
2
3. Unscrew to remove the wing nut
while keeping the foam gasket
against the faucet body (Fig. 6B).
4. Holding the foam gasket in place,
lower the Auxiliary Faucet stem
and tubes through the hole in the
sink ledge or counter (Fig. 7B).
5. With an assistant holding the
faucet in place, reach up from
below the counter and slide the
wing nut onto the threaded faucet.
Position the faucet in the desired
orientation and tighten the wing
nut to secure the faucet in place
(Fig. 8B).
Fig. 4B
Fig. 5B
Fig. 6B
Fig. 7B
Fig. 8B