Physical Interface; Power Consumption; Mounting To A Tripod Or Optical Table - Raptor Photonics HAWK 252 User Manual

4.2 Physical Interface

2

4.3 Power Consumption

Unit input power specification is +12V DC +/- 0.5V with <15W power dissipation when the
TEC is disabled. An additional 5W may be required if the full drive to the TEC is required.
This will be dependent on environmental conditions and the TEC temperature set point.
The set point for the TEC cooling is +15 °C. The TEC power is automatically adjusted to try
and achieve the set point temperature. For low ambient temperatures or with additional heat
sinking, less than 5W may be applied to the TEC to achieve the set point.

4.4 Mounting to a Tripod or Optical Table

The camera has a ¼-20 BSW (Whitworth), threaded hole to mount to a tripod or an optical
table.
HAWK-252/USER-MANUAL/REV1.0/02-20
1
3
4
1. 3M CameraLink connector
(TyOUT)
Part #: 12226-1150-00FR
2. SMA connector: Trigger Out.
Single ended, source impedance =
51 Ω, capable of sinking and
sourcing 32mA and will have an
output voltage of 3.3v i.e. TTL
compatible.
3. SMA connector: Trigger In.
Single ended, termination impedance
= 510 Ω, capacitive load = 200 pF,
TTL compatible.
4. 4 Pin Hirose connector
Part #: HR10A-7R-4PB(73)
6