Image State - Raptor Photonics HAWK 252 User Manual

8.4 Image State

The image state of the camera can be adjusted from the "Image State" tab in XCAP. The
camera has four different image state options:
Gain Corrected
•
Raw Data
•
• Test Pattern 1
Test Pattern 2
•
By default, the camera will be running in "Gain Corrected" which is what Raptor recommends
using the camera in. If wanting to obtain the raw data from the camera without the gain
correction, the "Raw Data" state can be used.
There are two different test patterns which can also be enabled.
This controls are shown in Figure 11.
Figure 11: Image State Control.
HAWK-252/USER-MANUAL/REV1.0/02-20
16