Frame Rate And Triggering Modes - Raptor Photonics HAWK 252 User Manual

8.2 Frame Rate and Triggering Modes

The frame rate state and trigger mode of the camera can be controlled from the "Trigger" tab
of the XCAP GUI, shown in Figure 7.
Currently, the camera runs only at 25Hz. This will eventually be adjusted so that a few
different discrete frame rate options can be selected.
The trigger state of the camera can also be adjusted. By default, the camera is set to Internal
trigger mode, Integrate Then Read. If wanting to externally trigger the camera, this can be
performed by selecting "Ext. Trigger" from the "Trigger Mode" dropdown box.
Figure 7: Frame Rate and Trigger Mode Controls.
13
HAWK-252/USER-MANUAL/REV1.0/02-20