Table of Contents
Advertisement
ATTENTION
Do not wipe the device with alkali
cleaning agent, alcohol, thinner,
benzene, nail polish remover or any
other solvents.
Failure to comply may cause
Prohibition
damage to the surface of the device.
Avoid allowing the electrode head to
come into contact with any other
metal surfaces.
Failure to comply may result in a
Prohibition
malfunction of the device or injury.
Do not look directly into the LED light.
When using the LED light to treat areas around the eyes and the eyelids, be sure to close
your eyes and keep the electrode head at least 5 cm away from the skin.
Prohibition
Failure to comply may cause damages to your eyes or skin.
Do not use COOL Mode continuously.
If the mode is used for continuous treatments, the head will not become fully cool.
Have an interval of at least 30 minutes between treatments.
Prohibition
Be sure to comply with the following points.
Failure to comply may cause an accident, injury or a malfunction of the device.
• Do not use continuously on the same area.
• Use the device appropriately based on your skin condition.
• Do not use the device after sunbathing, or in combination with peelings, skin packs or
Must Comply
other treatments.
• Be sure to turn the device off after use.
Stop using the device if you feel any physical discomfort during use.
Check carefully to make sure there is no skin abnormality before using the device.
Stop using the device immediately if the treatment does not agree with your skin.
Must Comply
Use only Level 1 upon the first use and until you are accustomed to use.
Failure to comply may cause an accident or injury.
Must Comply
5
Do not use the device on pets.
Failure to comply may cause an
injury.
Prohibition
Do not place the device in an
unstable location. Do not drop or
strike the device.
Failure to comply may lead to a
Dropping of
malfunction of the device. An injury
the device is
may also be caused if the device is
prohibited
dropped on a foot or other body
parts.
When Using Outside of Japan
WARNING
Be sure to use in an operating voltage range between 100 and 240 volts.
Failure to comply may cause a fire, electric shock or failure of the device.
Must Comply
Be sure to check the plug configuration and the voltage of the power outlet before use.
Failure to comply may cause a generation of heat, fire or malfunction of the device.
Combustion
warning
The plug configuration and voltage may vary depending on the region and the type of accommodation.
Always be sure to check for compatibility before using the device.
For information about plug adapters, consult a travel agency or a consumer electronics retailer.
6
Advertisement
Table of Contents
