After Treatment; Troubleshooting - Ya-man Photo PLUS Prestige SS M21 User Manual

After Treatment

How To Clean
To keep the product clean, please be sure to clean it after each use.
1
Disconnecting the AC adapter
2
To clean the device and electrode head, wipe them with a damp and
well-wrung cloth to remove any dirt. Wash the cotton stopper with
water after removing it from the main unit.
• Refrain from using an alkali cleaning agent, alcohol, thinner, benzene, nail polish remover or any
other solvents.
• Do not leave the device with lotion or gel on it.
3
Wipe the entire device with a dry cloth and store it after removing
all moisture.
Storage
 If you will not be using it for an extended period, clean the device before storing it.
 When the device is not in use, disconnect the AC adapter from the main unit and wall outlet.
 Avoid storing the device near a heater or in a bathroom or other high-temperature/high-humidity location.
Also, avoid locations where there is exposure to direct sunlight or unstable.
 Keep the device out of the reach of children.
Maintenance and Inspections
 If you will not use the device for an extended period, be sure to inspect it carefully and check that the device
works properly and safely before restarting use.
 If the device is malfunctioning, go to 'Checklist for Possible Problems' (pages 18-19) and attempt to identify
the problem before arranging to have the device repaired. If the problem persists, contact your local
distributor with a proof of purchase (page 21).
 If the device malfunctions, appears damaged or needs a service, please contact your local distributor.
17

Troubleshooting

Checklist for Possible Problems
Problem Possible Causes
→
The AC adapter is not
plugged into the wall socket.
The device does not turn
on.
→
The adapter is not plugged
into the device.
→
The device was used
The device is too warm.
continuously.
The level (intensity) of RF,
LED, Cooling and
Micro-current functions
cannot be changed.
The electrode head is not in
→
the correct position.
EYE Mode does not
function.
→
The EYE Mode electrodes
are not touching the skin.
→
You cannot feel any
Vibrations are turned off.
vibration.
→
COOL Mode was used
continuously.
The device is being used in
COOL Mode is not very →
an environment with a
cool. temperature exceeding the
recommended range.
→ The outside of the electrode
head will not cool down.
Solutions
→
Turn the power on by
connecting the AC adapter.
→
Plug adapter into the device.
Turn the device off and wait
→
at least 1 hour before
restarting use.
The level can only be changed
for EMS, Ion and DYHP
functions.
EYE Mode will not function
unless the electrode head is
→
properly rotated 180°. Rotate
the electrode head so that it is in
the correct position (page 11).
Please make sure both of the
→
two EYE Mode electrodes
are touching the skin at the
same time (see page 16).
Press the Vibration (VIB)
→
button to switch on the
vibration function.
Turn the device off and wait
→
at least 30 minutes before
restarting use.
Try using in an environment
→
with the temperature
between 15° C and 30° C.
→ Only the inner electrode
head becomes cool.
18