Basic Safety Measures - HADEF 59/18 Installation, Operating And Maintenance Instructions

DANGER!
It is not allowed:
 Pulling loose of stuck loads, dragging of loads and inclined pulling is not allowed.
 The use in area at risk from explosion.
 In reactor containment vessels.
 To transport people with the equipment.
 The device is not suitable for use on stages and in studios!
 Persons must not stand under a suspended load.
 Motor drive of the equipment.
 Blocking of the loose chain end.
 Charging the loose chain end.
 Dragging of loads with motor-driven hoists.
2.5

Basic safety measures

 Observe installation-, operation and maintenance instruction.
 Take notice of caution notes at units and in the manual
 Observe safety distances.
 Take care for a free view on the load.
 Only use the hoists appropriately.
 The equipment is to be used exclusively for movement of goods. Under no circumstances my persons be
moved.
 Never load the devices beyond their working load limit.
 Pay attention to the accident prevention regulations (UVV).
 Should the hoist be used outside of Germany, please pay attention to the national regulations that apply.
 Supporting structures and load-attached devices used in conjunction with this equipment must provide an
adequate safety factor to handle the rated load plus the weight of the equipment. In case of doubt, consult
a structural engineer.
 If the equipment has not been used for a period of time, carry out visual checks of all main components
such as chains, load hooks etc. and replace any damaged parts with new, original spare parts before
putting the equipment back into operation!
 Do not use a hoist that is defective, pay attention to any abnormal noise it makes during operation.
 Stop working immediately in case of disturbances and remedy failures.
 Any damage and faults must be reported to a responsible supervisor immediately.
 If the unit is put into motion, any persons in the immediate vicinity must be informed by calling to them!
 Please pay attention to the regulations for load carrying devices UVV for both positive and non-positive
methods of attaching loads.
 The lifting tackle or the load must be securely attached to the hook and be seated at the bottom of the
hook.
 The safety catch of hooks must be closed.
 When charged, the housing may not be in contact somewhere.
 Stop lowering the load when the bottom block or the load is being set down or is prevented from being
lowered further.
 The load chain must not be twisted.
 Twisted chains must be aligned before attaching the load.
 The correct alignment of the chain links can be seen from the weld seams.
 The chain links must always be aligned in one direction.
 Don't bump against something with load or hook
 We recommend a unit with sliding clutch to prevent overload, when the unit is used for tightening,
 Motor drive is prohibited.
6
Illustration 1
5.52.159.00.01.04