Pulleys; Load Hook; Gear; Gear Spring Pressure Brake - HADEF 59/18 Installation, Operating And Maintenance Instructions

Safety lever hoist
Table of Contents

Advertisement

12.2

Pulleys

Use
Pulleys
12.3

Load hook

 Check bearings and pulleys yearly
 Clean and lubricate the bearings of hooks and pulleys with grease
 Slight bearings are maintenance free
 When bearings resp. slight bearings are worn of, change the complete pulley
Use
Load hook
bearing
12.4

Gear

Regular checks of lubrication are necessary. The teeth must be cleaned and re-lubricated after approx. 3
years. We recommend to use a lubricant of class EP2 or similar products. In case of severe conditions of
use (e.g. dust, regular lifting of the nominal load,etc.), please shorten maintenance intervals.
12.5

Gear spring pressure brake

During the check, brake lining wear is verified. The brake linings must be replaced when the wear limit is
already reached at one position of the lining, - as this can be the case when wear of the linings is irregular.
CAUTION!
The brake linings must be free from fracture. Avoid oil, grease, dirt and humidity on the brake linings as this
increases wear.
The brake lining for the ratchet lever hoist is tested for the whole product lifetime - under the precondition of
appropriate use - and must only be replaced in case of extraordinary wear.
NOTICE!
According to EN 13157 lifetime is 1500 operating cycles (lifting/lowering movements) with 300 mm lift with
nominal load and normal operation conditions.
Use by heavy conditions can shorten the product lifetime. In these cases, the thickness of the brake lining
must be checked more than 1x yearly. The ratchet wheel with the brake lining must be replaced when the
wear limit is reached or wear of the lining (one one side) is clearly visible.
12.6

Overload protection

DANGER!
The factory setting of the overload protection/slipping clutch is secured by sealing. In case of any changes
will void the warranty. Should maintenance be necessary, please contact a service company authorized by
the manufacturer.
12.7

Lubricant - Selection

FUCHS
SHELL
Renolit FEP 2
Alvania EP 2
Stabylan 5006
--
--
--
18
ESSO
MOBIL
Unirex EP 2
Mobilux EP 2
--
--
--
--
Chain lubricant OKS 451
Recommendation
FUCHS
RENOLIN PG220
Recommendation
FUCHS
RENOLIN PG220
TOTAL
CASTROL
MULTIS EP2
--
--
Optimol Viscoleb 1500
--
--
Interval
Acc. to demand
12 month
Interval
Acc. to demand
12 month
KLÜBER
--
Klüberoil 4UH 1-1500
Wolfracoat 99113
5.52.159.00.01.04

Advertisement

Table of Contents
loading

Table of Contents