Check - Locking Mechanism; Service; Load Chain - HADEF 59/18 Installation, Operating And Maintenance Instructions

11.8

Check - locking mechanism

Check for dirt, corrosion and room to move freely of
the bar.
Grease the bar slightly.
Check coorect activation moment of the bar with a
pulling force scale.
Capacity
kg
1600 – 9000
If the activation value is exceeded or fallen below,
re-adjust with the disc adjusting screws placed
sidewise.
12

Service

12.1

Load chain

Wear at the links is mainly due to insufficient maintenance of the chain.
To ensure optimal lubrication of the links, the chain must be lubricated at regular intervals, depending on
usage.
 Lubricate the chain with oil that creeps.
 Always lubricate the chain when it is not under load so that the oil can wet the links affected by wear. It is
not sufficient to lubricate the chain from the outside, as this will not ensure the formation of a lubricating
film within the links. The adjacent link points must always be lubricated to prevent excessive wear.
 If the same lifting operations are carried out constantly, the switching area from a lifting to a lowering
movement must be given special attention.
 Thoroughly effected lubrication of the chain will prolong the life of the chain by approx. 20 times,
compared to dry run with unlubricated chain.
 Wash dirty chain with petroleum or a similar cleaner, under no circumstances heat the chain.
 If there are environmental influences that foster wear, such as sand, a dry lubricant should be used, e.g.
graphite powder.
 When lubricating the chain's condition of wear should be checked.
Use
Load chain
CAUTION!
Do not use grease for lubrication of load chain.
Without lubrication, manufacturer's warranty and/or liability will be void.
5.52.159.00.01.04
Necessary pulling force
kg
min max
1,7 2,0
oil for example: FUCHS RENOLIN PG 220
or special chain lubricant
Use NO grease!
Recommendation Interval
0,2 l 3 month
17