Advertisement
LCD Display
DISC numeric indicator
Control buttons
SENS
Press SENS then + or – to increase or decrease the sensitivity. The LCD will display the
current sensitivity level. If the target depth is beyond the maximum the sensitivity of the
detector, the target will not be found.
DISC numeric range (0-80)
Press DISC then + or – to select the desired DISC number. If the target material is beyond
the DISC range, it cannot be discerned.
Note
The highest DISC numeric setting is 80. If the DISC value is set to 80, all targets less
than this number will not be detected.
NOTCH
Press NOTCH, then + or – to select the target to be notched. The cursor above the selected
target will flash. Press NOTCH again, the target name below the cursor will disappear.
Low BATT indicator
Target numeric indicator
Target indicator
DISC/NOTCH
indicator
SENS/DEPTH
indicator
Advertisement
