Advertisement
OPERATION
Using Headphones
1.
Headphones or earphones with in-line volume controls are recommended.
2.
Insert the headphones' 3.5mm plug into the PHONE jack. The internal speaker will
automatically mute when headphones are connected.
3.
Set the volume to the desired setting.
Listening safely
To protect hearing, set the volume to the lowest setting initially.
Before you begin listening, adjust the volume to a comfortable level.
Do not listen to extremely high-volume levels. Extended high-volume listening can
lead to permanent hearing loss.
Do not wear headphones while operating the detector near high-traffic areas. Pay
attention to traffic safety.
Turning on the detector
Rotate the volume switch clockwise away from the off position to power on the detector and
the backlight. The LCD will display all symbols, and the detector sounds low, medium, and
high tones respectively. After about 2 seconds, the detector enters the standby state. The
default mode is DISC; the LCD will display DISC of 00 and SENS of 6 bars.
To learn how the detector reacts to different metals, it is advised to test the unit it before it is
used for the first time.
Note:
If no metal is detected within twenty minutes, the detector will automatically
turn off.
Advertisement
