AT&T MLC-5 Supplementary Manual page 2

TELEPHONE
MLC-5 Cordless Telephone Handset
Card used to note
Button
feature or line assigned
Labeling
to each line button.
Card
Button used to change
Channel
Button channels for improved
reception.
Five buttons with red
Line
lights, used to make/
Buttons
receive calls. Any
unlabeled buttons can
be programmed with
features.
Low Light blinks when
batteries have less than
Battery
15 minutes of use
Light
remaining (tone also
generated).
Message Light illuminates
Light when you have a voice-
mail message, fax, or a
message from the
system operator.
MLC-5 Cordless Telephone Base Unit
Antenna Retractable antenna;
extend fully for clear
reception.
Metal contacts that
Battery
recharge the handset.
Contacts
Clean contacts
periodically with a soft
pencil eraser.
Channel Electronic display of
Indicator the channel currently
used or programmed.
A "P" displays when
the telephone is being
programmed.
Directory Erasable card used to
Card record the telephone
number assigned to the
cordless telephone and
to list feature codes.
Light illuminates when
Message
Light you have a voice-mail
message, fax, or
message from the
system operator.
Imprinted Buttons
Imprinted buttons, including dedicated
feature buttons, cannot be changed.
Press to put a call on hold.
Hold
Red light flashes while call
is on hold. During hold,
phone beeps every 60
seconds. More than one
call can be on hold at a
time.
Press to show on the
Status
status of the handset line
button lights, except for
On/Off, Low Battery, and
Message. Light turns
off after 20 seconds.
Transfer Press to send a call to
another phone.
Press to change the
Channel
channel to improve
reception.
Press to activate the
On/Off
handset to make or
answer a call.
Mode Charge - a light that
illuminates when the
Lights
handset is in the the base
unit and the batteries are
c h a r g i n g .
Talk - a light that
illuminates when the
handset is removed from
the base unit and, is turned
on using On/Off button.
Program - a light that
illuminates when the T/P
switch is set to P for
programming.
Ringing Sliding control used to
adjust the volume of the
Volume
base unit's ring.
Control
Switch used to test and
T/P
Switch
program the telephone.