Bosch WAU28PH9GB User Manual page 59

Fault
flashes.
lights up.
flashes.
All other error codes.
The appliance is not
working.
Cause and troubleshooting
The automatic voltage control system detects an un-
authorised voltage under-usage.
No remedial action possible.
▶
Note: If the power supply is stable, the programme
continues to run as normal.
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
If intelligent dosing is activated, reduce the basic
▶
dosage → Page 45.
If you dose manually, reduce the amount of deter-
▶
gent for the next washing cycle with the same load.
The temperature is too high.
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 42
▶
Water level is too high.
Start the Drain programme.
▶
Laundry is caught in the door.
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press to start the programme.
4.
Door is not closed.
Close the door.
1.
Press to start the programme.
2.
Malfunction
Call the after-sales service.
▶
→ "Customer Service", Page 70
The mains plug of the power cord is not plugged in.
Connect the appliance to the power supply.
▶
The circuit breaker is faulty.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Troubleshooting en
59