Odorox Slimline Owner's Manual page 13

STEP 9: If wiring from back of unit, also mark the 7/8 inch hole onto the mounting surface for the main electrical
connection.
STEP 10: Set back panel aside.
STEP 11: If wiring from back of unit, cut out hole size as needed for electrical connector, and install electrical
service.
STEP 12: Ensure electrical service to this unit is turned off and locked out before continuing. Install electrical
connector (not supplied) onto back panel, and make proper electrical connections.
STEP 13: Secure back panel to mounting surface using #10, 1 ½ inch wood screws (not supplied) for typical wood
frame construction. If construction type is different, ensure proper support as per construction type
and weight of Hydroxyl Generator.
STEP 14: If wiring from the side, install electrical service and make proper electrical connections.
STEP 15: Re-install lamp optic following these instructions:
Caution: Use clean leather gloves and eye protection when
handling the optics in this unit
• Gently press lamp into the three lamp supports.
• Re-connect lamp connector holding the lamp base with one hand, and lamp
connector with other hand.
Note: Lamp connector is keyed. If unable to connect lamp connector with lamp base,
rotate lamp connector 180 degrees and try again.
• Ensure lamp connector and lamp base are firmly pressed together.
WALL-MOUNT INSTALLATION
Odorox Slimline
® TM
11