Odorox Slimline Owner's Manual page 12

WALL MOUNT-INSTALLATION
STEP 6: Knock out four pre-punched holes on back panel.
STEP 7: If wiring unit from back, knock out pre-punched 7/8 inch hole for electrical connector. If wiring from the
side, knock out pre-punched hole on the side of the back panel.
STEP 8: Determine the desired installation location. This location must conform to the Warnings and Caution
instructions discussed earlier. This Slimline unit must be anchored securely to a wall or ceiling. The mounting
screw locations are designed for standard wood/metal framing with studs on 16 inch centers. Using the back
panel as a template, mark the screw locations onto the mounting surface so that unit can be screwed directly
to the main studs. If there is not sufficient support at the desired location, support members must be added.
Installer is responsible for the proper installation of this Hydroxyl Generator as per local building and
electrical codes.
10
Owner's Manual