Lathe Preparation - Pro-Cut X9D Technical Manual

LATHE PREPARATION

Before mounting the lathe, check the cutting tips and make sure they are ready for use. The cutting tips are one of the most
critical components of the machine. It is vital that they are Pro-Cut brand tips in good condition and properly mounted. Each cut-
ting tip has three corners which may be used. The correctly installed tip is wider on the top and has a groove, or dots, facing up.
You should get at least 10 cuts per corner. However, tip life is affected by variables such as rust or ridges. In order to determine
when to rotate tips, monitor rotor finish. If the rotor finish begins to look inconsistent, or feels rough to the touch, tips should be
rotated. Tips that are chipped or cracked should never be used.
Be sure that the tip pocket is clean before positioning the tip. Any foreign material pinched under the tip will cause problems.
NOTE 1: The lathe has a powerful motor which requires 15 amp service.
All extension cords must be at least 12 gage and less than 25 feet; drop
light cords are not recommended.
NOTE 2: Use only Pro-Cut Cutting Tips (50-742 or 50-778). Although
other tips may fit the machine, only Pro-Cut tips have been specifically
engineered in tandem with the Pro-Cut lathe. Using a non-Pro-Cut tip may
compromise lathe performance and result in poor surface finish.
PG / 800.543.6618
22
CHECK CUTTING TIPS
PREMIUM PLUS CUTTING HEAD SHOWN
When the tip is mounted
correctly, the chip breaker
and dots face up.