Unpack; Required Tools - Emerson Rosemount 975UF Reference Manual

Installing the detector
June 2021
2.2

Unpack

Procedure
1. Upon receipt of your detector, verify that you have received the following contents:
2. Check and record the following:
Postrequisites
If the installation is not completed in a single session, secure and seal the detectors and
conduits/cable entries.
2.2.1 Checking the product type
Confirm your product has the configuration options you ordered.
Check the detailed model number on the label and compare this information with the
descriptions contained in
2.3

Required tools

The operator can install the detector using general purpose tools and equipment.
Table 2-1
Table 2-1: Required Tools
Tool
Hex key 3/16-in.
Hex key ¼-in.
Flat screwdriver 6 mm
Flat screwdriver 2.5 mm
Hex key 5/16-in.
28
• Delivery form
• Flame detector
• Plastic weather cover
• Quality document
a) Verify the appropriate purchase order.
b) Record the model number and serial number of the detector and the
installation date in an appropriate log book.
c) Verify that all components required for the detector installation are readily
available before beginning the installation.
Ordering
lists the specific tools required to install the detector.
Function
Open and close the detector
cover (for wiring).
Mount the detector on the tilt
mount.
Connect ground terminal.
Connect wires to the terminal
blocks.
Scrw detector plug.
information.
Reference Manual
00809-0100-4977
Comments
Part of the kit
Part of the kit
Standard tool
Standard tool
Part of the kit
Emerson.com/Rosemount