Safety Instructions; Outputs Specifications And Connections; External Power Supply Specifications And Connections; Wiring Diagrams - Zennio FANinBOX 230V 1CH Technical Documentation

OUTPUTS SPECIFICATIONS AND CONNECTIONS

CONCEPT
Number of outputs
Output type
Maximum recommended load per output
Minimum load per output
Short-circuit protection
Overload protection
Connection method
Cable cross-section
Outputs per common
Maximum response time
Mechanical lifetime (min. cycles)
Electrical lifetime (min. cycles)
¹ Lifetime values could change depending on the load type.

EXTERNAL POWER SUPPLY SPECIFICATIONS AND CONNECTIONS

CONCEPT
Voltage
Connection method
Cable cross-section

WIRING DIAGRAMS

Attaching FANinBOX 230V 1CH to DIN rail:
Removing FANinBOX 230V 1CH from DIN rail:

SAFETY INSTRUCTIONS

• Installation should only be performed by qualified professionals according to the laws and regulations applicable in each country.
• Do not connect the mains voltage nor any other external voltage to any point of the KNX bus; it would represent a risk for th e entire
KNX system. The facility must have enough insulation between the mains (or auxiliary) voltage and the KNX bus or the wires of other
accessories, in case of being installed.
• The facility must be equipped with a device that ensures the omnipolar sectioning. Installation of a 10A mini-circuit-breaker is
recommended. To prevent accidents, it must remain open in case of manipulation of the device.
• Once the device is installed (in the panel or box), it must not be accessible from outside.
• Keep the device away from water (condensation over the device included) and do not cover it with clothes, paper or any other material
while in use.
• The WEEE logo means that this device contains electronic parts and it must be properly disposed of by following the instructi ons at
http://zennio.com/weee-regulation.
© Zennio Avance y Tecnología S.L.
DESCRIPTION
1
Relays based control device
100W
30W
NO
NO
Screw terminal block
0.5-2,5mm² (IEC) / 26-12AWG (UL)
1
15ms
3 000 000
100000 @ 8A / 25000 @ 16A (VAC)
DESCRIPTION
230VAC
Screw terminal block
0.5-2,5mm² (IEC) / 26-12AWG (UL)
Figure 2: Wiring diagram of a fan
Edition 4
⚠ In order to ensure the expected
status of the relays, please check
that the device is connected to the
KNX bus before energizing the
power circuit.
⚠ Use for ceiling fans. Do not
use
damages.
Figure 3: Mounting FANinBOX 230V 1CH on
DIN rail
Futher information www.zennio.com
other load to avoid
Page 2/2