Flying - Getting Ready For Take-Off - Reely GeNii Mini RtF Operating Instructions Manual

5.2.1 Switching modes (Mode 1/Mode2)
1. Initiate mode switching:
- For Mode 2: Move the left joystick to the lowest position and hold down the <One Key Takeoff/Landing> button
at the same time.
- For Mode 1: Toggle the right joystick to the lowest position and hold down the <Photo/Video> button at the
same time.
2. While holding down the button from step 1, turn on the remote controller by pressing the <Power> button until
you hear a beep sound.
3. Release the joystick. The mode is changed.
5.3 Flying – Getting ready for take-off
Requirements
• The flight battery and the remote controller battery are fully charged.
• You understand what the controls do.
5.3.1 Powering on and initializing the aircraft
WARNING
Always power on the remote controller before you turn on the aircraft to prevent accidents.
1. Put the aircraft on a flat surface.
2. Power on the remote controller. Hold down the <Power> button for 2 seconds (Fig. A).
3. Power on the aircraft:
- Push the <Power> button once (1x), then press again and hold for 2 seconds (Fig. B).
- The initializing tune plays.
4. Wait for the self-check and frequency matching procedure to complete.
- The procedure takes about 30 seconds.
- When the indicator lights turn from flashing or solid blue to flashing or solid green the procedure is completed
(Fig C).
Fig. A
Fissssssss
Fig. B
sss
Fig. C
Fissssssss
13