Advertisement
PROTECTION WHILE THE SYSTEM IS ARMED: (continued)
If the optional single stage shock sensor is installed, any strong impact to the vehicle will
cause the shock detector to trigger the alarm when armed. If the optional 2-stage shock
sensor is installed, any lesser impact will cause the pre-detect stage of the shock sensor to
emit a series of short warning tones from the siren when armed.
If the optional stater interupt is installed the vehicle starter circuit is disabled, even with the
ignition key the vehicle will not start. Should an attempt be made to start the engine, while
the PRO 9842 is armed, the starter circuit will remain interrupted.
DISARMING THE SYSTEM
As you approach the vehicle, press and release the left button on the keychain transmitter.
The parking lights will flash two times, the siren will chirp twice, and the dash mounted LED
will turn off. If you have the optional door lock/unlock circuit installed, the doors will unlock.
Note: If the passive arming mode was selected at the time of installation, the dash mounted
LED will start flashing rapidly indicating that the system is rearming. Opening any door will
suspend the automatic arming.
If the parking lights flashed three times, and the siren chirps four times, this indicates that
the alarm system had been triggered in your absence. Before turning on the ignition key,
examine the dash mounted LED's flash pattern. The number of flashes identifies the
triggered zone. For additional information, refer to INTRUSION WARNING SIGNALS found
later in this manual.
If the siren did not sound upon disarm, then the chirps have been turned off. Refer to the
section titled ELIMINATING THE ARM/DISARM CHIRPS.
SILENT DISARMING
1. As you approach the vehicle, press and hold the left button of your key chain transmitter
for two seconds, or until the system responds.
The parking lights will flash twice, and the dash mounted LED will turn off, confirming that
the system is disarmed. The siren will not chirp. If you have the optional door lock/unlock
circuit installed, the doors will unlock.
Note: If the passive arming mode was selected at time of installation, the dash mounted
LED will start flashing rapidly indicating that the system is rearming. Opening any door will
suspend the automatic arming.
If the parking lights flashed three times, and the siren chirps four times, this indicates that
the alarm system had been triggered in your absence.
VALET/PROGRAM/MANUAL OVERRIDE SWITCH
The valet switch allows you to temporarily prevent the PRO 9842 from arming, eliminating
the need to hand your keychain transmitter to parking attendants or garage mechanics.
When the system is in the valet mode, all alarm functions are by-passed, however the
remote panic feature, and the optional remote door lock/unlock will remain operational.
To enter the valet mode:
1. Start with the valet switch in the "off" position
2. Turn the ignition switch to the "on" position.
Page 3
Advertisement
