SPIT 372 Operating And Maintenance Instructions Manual page 12

Instructions for use
Before using the
equipment
Area of use
Electronic on/off
switch
Starting / stopping
Auxiliary handle
Torque limitation
10
Consider the main voltage: The voltage of the source of supply is
the same that shown on the information plate on the equipment.
This tool is solely determined for hammer drilling and chiseling mainly
mineral materials (e.g. concrete, masonry, limestone, ...). Improper
use may cause injury or damage the tool.
The electronic switch (4) is designed for continuous adaptation of the
rotation speed and impact energy to suit all operating conditions
(pebble dash, tiling, brick, concrete).
The further you press the switch, the higher the rotation speed and
impact energy.
After inserting the tool in the tool holder and putting the mode selec-
tor switch (3) in the right position, press the tool against the support
and operate the electronic switch (4).
To stop the tool, release the electronic switch (4).
Do not use the tool without its adjustable handle (6).
The adjustable handle rotates through 360°.
Undo the adjustable handle and put it in the position which best suits
the work position.
Tighten the handle carefully after you have put it in the desired posi-
tion.
If the drilling tool gets stuck, the torque limiter stops rotation, which
avoids losing control of the tool.
The tool must be held firmly with both hands and the user must be in
a stable position (e. g. not on a ladder).